小弟不懂音響 之前都是聽耳機 IE7 IE80 IE80S 都有入手
訊源是IPC =>ZX300
最近想聽電腦的音響 去試聽後 最後選定了丹拿的XEO4
原先是 水母1代
因為台灣售價跟國外差距真的太大 到達2倍
小弟月薪不高 只是真的喜歡聽音樂 最後下定決心買了水貨 但也不便宜
最近一邊藍芽喇叭連接不到
想問是因為傳輸盒的問題麻? 才入手2個月真的慘
想麻煩各位大大有沒有可維修的廠商
海外代購的商人跟當初說的不太一樣
是否有人可以介紹維修廠商給小弟 拜託拜託
P.S
XEO4 的音質真的不錯 很喜歡 不輸給入耳式耳機的音質
Troubleshooting Xeo with Hub / Connect
Please note: The following only applies to Xeo Hub / Xeo Connect (Xeo 2 / Xeo 4 / Xeo 6)There are a number of steps that can be taken to ensure optimum performance when using Hub / Connect with Xeo.
- Reset the Xeo speakers and Hub / Connect. Read more here.
- Make sure that any Wi-Fi receiving or sending devices are located at least 50 cm / 20 inches from both the Xeo speakers and from the Hub / Connect.
- Try using a different Zone setting on the speaker (Red / Green / Blue switch on the Xeo speaker).
- Try using a different ID setting on the Hub / Connect (A / B / C switch). After the change, remember to powercycle the speakers and then re-select the ID via the Xeo Master Remote Control.
- Only applies to Xeo 2, Xeo 4 / Xeo 6 do not support High Resolution Mode: Try changing the Connect from High Resolution to Multiroom Mode, and vice-versa. After the change, remember to powercycle the speakers.
- Make sure your digital source outputs a PCM stereo signal. Read more here.
- Double check if your source is playing and works in a different setup.
- If possible, try fixing available Wi-Fi networks to a specific frequency range. This frees up frequencies for the Connect. Please read the documentation of your wireless router for details.
關閉廣告