上坡起步輔助系統故障
https://www.youtube.com/watch?v=PGYvrVRCyV4
回文中是說後來回原廠換了煞車踏板上的開關
"they replaced a switch this time on the brake pedal"
國外論壇有些是說換掉RCM (Restraints Control Module)
送回台灣原廠看怎樣處理吧
剛看到一個解決步驟
原文網址 :http://fordtransit.org/forum/viewtopic.php?f=2&t=171568
打開開關時,請檢查"小山"狀的起動燈是否短暫亮起。
1)點火
2)踏下所有三個踏板並保持住,直到起步指示燈閃爍 - 這應該在約8秒後。
3)放開踏板。
注意: 不要踏住踏板超過20秒
Check that the hill start light comes on briefly when you turn on the ignition.
The same pedal push combination turns hill start assist on and off.
1) turn on the ignition
2) push all three pedals and hold until the hill start indicator flashes - this should be after about 8 seconds.
3) release the pedals.
NOTE: don't hold the pedals down for more than 20 seconds